|
|
Shank Surface
SurCh-Sc is ideal to control even regions (coated and uncoated).
Even smallest defects in the range of 10μm x 10μm are detected reliably.
|
Surface of a plane shank with minor defects
|
Not only plane shank surfaces can be inspected, but also complex structures, e.g. knurls, hollow shafts, borings, etc.
Some examples are listed in the following pictures:
|
Knurl without deformations
|
|
Knurl is ok, but scratch on shank surface below.
|
Additional to the standard shank control, a precise measurement of the hole is easily possible
|
|
Hollow shaft with scratch
|
|
|
|
